Home > Product > Fasson > 53825

Print this Page
Inverted Face MaxFlexTM Silver FSC®/S246/40#SCK
Spec# 53825
Facestock:
MaxFlexTM Bright Silver FSC® Inverted Face is a C1S metallized paper with the metal side down, leaving an uncoated paper surface for printing. The metal provides limited barrier properties, as well as offering graphic appeal for clear containers.

FSC® Certification ensures that products come from well-managed forests which provide environmental, social, and economic benefits. The FSC® Chain of Custody Certification verifies that FSC® Certified material is identified or kept segregated from non-certified or non-controlled material through this chain.




Basis Weight:
56.0# per ream ± 10%
(500 sheets 25" x 38")


Caliper:
0.0026 inches ± 10%


Tensile:
MD 25# per inch width
CD 13# per inch width


Tear:
MD 40 grams per sheet
CD 45 grams per sheet


Stiffness:
MD 55 mg
CD 35 mg

Adhesive:
S246 is a general purpose permanent rubber based adhesive featuring high initial tack and ultimate adhesion. S246 is suitable for applications requiring FDA compliance with Title 21, Section 175.105 of the Code of Federal Regulations (21 CFR 175.105). Compliance with this regulation permits the use of this adhesive in applications for which the adhesive either (1) is separated from the food by a functional barrier, which will prevent the migration of any of the adhesive components to the food; or (2), has incidental contact with food limited to the trace amount at the seams or the edges of the label.



Type:
Hot melt rubber


Minimum Application Temperature:
+40° F


Service Temperature Range:
-65° F to +160° F


Typical Performance Data: 60# C1S paper at room temperature on standard lab panels



Stainless Steel
Loop Tack:
Peel Adhesion:

6.2 lbs
3.0 lbs-tear


HDPE
Loop Tack:
Peel Adhesion:

4.3 lbs
2.2 lbs-tear


Polypropylene
Loop Tack:
Peel Adhesion:

4.5 lbs
3.0 lbs-tear


Glass
Loop Tack:
Peel Adhesion:

6.0 lbs
2.6 lbs-tear






Liner:
40#SCK is a bleached super calendered kraft stock featuring high internal strength, toughness, and tear resistance. Used primarily for roll-to-roll label applications.



Basis Weight:
39.90# per ream ± 10%
(24" X 36" 500 sheets)


Caliper:
0.00236 inches ± 10%


Tensile:
MD 38.30# per inch width
CD 14.80# per inch width


Tear:
MD 32.60 grams
CD 40.80 grams

Total Construction Caliper (approximate): 0.0066 inches ± 10%



Optimal Storage Conditions
Unless otherwise specified in this document, ideally store at 72F and 50% RH